How do you put on an AC belt?

How to Change an A/C Belt

1. Make sure the car engine is off.
2. Slip the loosened serpentine belt off of the tensioner pulley by sliding it to the outside of the pulley.
3. Loosen the adjustment bolt on the air conditioner bracket, using a ratchet and socket or wrench.

How do you remove an AC compressor belt?

Step 3: Remove & Replace Belt.

1. Loosen (but do not remove) the four bolts (1) holding the motor in place.
2. Shift the motor towards the pump. The belt should be loose and easily removable.
3. Move the motor back to the original position to create proper belt tension.
4. Tighten the motor bolts.
5. Replace the belt. (

What does the AC belt connect to?

The belt connects the AC compressor clutch to the engine crankshaft, which allows the compressor to be turned via the engine’s power when activated. As with most automotive belts, the AC belt will either be a V-belt or a serpentine.

How do you put on a belt?

Insert your belt through the left-side loops first. Take the end of your belt, and begin inserting it into your belt loops with the loop on the front left side of your pants. Thread the belt end through each loop, pulling the belt through as you go. Once you reach the last loop, buckle your belt.

Is serpentine belt same as AC belt?

A Serpentine Belt is what it is. The engine has a belt inside it. The steering pump, alternator, water pump, and air conditioner compressor are all powered by this belt. …

How long does it take to change AC belt?

(Remember, every car is different, and changing the belt on certain cars may require special tools.) Changing the belt should only take about 15 minutes. Make sure the car is switched off and cooled down before touching any part of the engine. Read your belt routing diagram.

What happens if your AC belt breaks?

If your serpentine belt wears out, becomes damaged or contaminated, or breaks, engine accessories will not be able to spin at the proper speed, leading to decreased power to the electrical system. Advances in material technology allow some belts to last more than 100k miles.

What causes AC belt to squeal?

A loud squeal is produced when the A/C is turned on. This symptom is usually caused by a loose or worn air conditioning compressor belt. This places a load on the engine and the drive belt that rotates the compressor. If the belt is loose or worn the belt can slip on the compressor pulley and emit a loud squeal.