How do I reset my electric fireplace?

SOLUTION: Turn all switches to the “off” position and unplug the unit from the wall for five minutes. After five minutes, power everything back on.

Why does my fireplace remote not work?

The following are the top reasons why remotes do not function: 1) Batteries do not have enough power or are installed incorrectly. 2) Misunderstanding on how the remote features operate the fireplace. 3) The slide switch on the receiver is not in the correct position.

How do you fix a electric fireplace that won’t turn on?

Electric Fireplace Won’t Turn On Now, check for faulty wiring. Some electric fireplaces have a built-in fuse box (refer to owner’s manual). Replace any burnt out fuses if applicable. When the remote doesn’t work (and the batteries aren’t dead of course), the problem usually lies with the circuit board.

Why is my Dimplex electric fireplace remote control not working?

If your Dimplex electric fireplace is new, the most likely cause of your remote control transmitter not working is that you haven’t initialized the remote control to the fireplace. If you haven’t initialized your remote control, here’s how you do it.

Do you need to read the Dimplex fireplace manual?

You don’t need to read the whole Dimplex fireplace manual. The Dimplex remote control has a range of about 50 feet. So, you don’t have to directly point it at the fireplace. The remote control can work even when obstructed by thick materials, such as a wall.

What is the range of Dimplex fireplace remote control?

The Dimplex remote control has a range of about 50 feet. So, you don’t have to directly point it at the fireplace. The remote control can work even when obstructed by thick materials, such as a wall. It is also supplied with 243 independent frequencies.

How do you reset a Dimplex heater?

Here are the steps to reset a Dimplex Heater. Make sure you isolate the supply. You can turn off the power at the fusebox or the power inlet where your heater is plugged in. You’ll need to grab a grip. There are two screws on either side of the heater. Unscrew them with the grip. You can now easily remove the front cover of the heater.