How much is an inducer motor for a York furnace?

$245 – $465, Installed The cost to replace a draft inducer motor in your gas furnace is between $245 to $465, depending on whether the parts and/or labor are covered by the furnace manufacturers warranty or not.

How long do furnace inducer Motors last?

A: On average, you can expect a well-built inducer motor to last around 20 years.

Why am I not getting power to my inducer motor?

If the draft inducer does not start then you probably either have a thermostat , thermostat wiring problem, electrical problem, control board problem or a bad draft inducer. Tape the blower door safety switch shut (if equipped) and set your thermostat so it is calling for heat.

What is the average cost to replace an inducer motor on a furnace?

Your furnace’s draft inducer motor removes toxic gases like carbon monoxide from the heat exchanger. The average cost to repair or replace a draft inducer motor is $200–$1,500.

How much does it cost to replace a inducer motor on a carrier furnace?

The average cost of a Carrier inducer motor replacement is between $800-$1800.

How much does it cost to replace a blower motor on a furnace?

How much does a furnace motor replacement cost? On average nationwide, a furnace blower motor replacement costs $400-$600, including parts and labor. A single-speed blower motor costs around $450 to replace while a variable-speed motor costs $600+.

What does a draft inducer motor do on a York Furnace?

The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat. Did you know that many York furnace parts can be installed in other brands such as Fraser Johnston, Evcon, Coleman, Luxaire, Guardian and Choice?

How do you seal a draft inducer motor on a furnace?

If you do not have a gasket, you can use high-temperature silicone sealant to seal the furnace. Furnace draft inducer motor assembly. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

What are the specifications of a furnace blower motor?

Furnace blower motor. This single-phase motor has the following specifications: Furnace blower motor. This single-phase motor has the following specifications: 1/3HP 240Volts 60Hz 3.1 amp 1050 RPM’s 4 Speed Open Enclosure 48Y Frame Single Phase CW 4″ Shaft