How do you reset a VTech InnoTab?

Once the system is off, press and hold the d-pad in between the up and left arrows, the HELP button, and the POWER button at the same time. When the white VTech screen appears, release only the POWER button. Continue pressing the d-pad and the HELP button until you see the Factory Reset screen.

How do you reset a VTech InnoTab 3S?

To do this, select “Settings” in the main menu. Select “My Name”. Finally, type in “R-E-S-E-T” and press the checkmark to finish. The tablet will shut off, and the system will be reset.

How do you change the battery in a VTech InnoTab 3S?

VTech Kids Main Content

1. Make sure the InnoTab® 3 or InnoTab® 3S is turned off.
2. Turn the unit over.
3. Remove any old batteries that may be in the toy.
4. Insert Battery Pack ① into the compartment on the right side and Battery Pack ② into the compartment on the left side.
5. Replace the battery covers.

How do you reset a VTech DigiGo?

Locate the reset hole on the bottom cabinet. Use a ballpoint pen or a tooth pick to press the button inside the hole, then press the Power button for 3 seconds to restart DigiGo™.

How do I connect my InnoTab 3S to my computer?

To connect InnoTab® 3 or 3S to your computer, locate the USB port on the bottom of your InnoTab® 3 or top right corner of your InnoTab® 3S. Open the rubber port cover. Insert the small end of the USB cable into the port on your InnoTab® 3 or 3S. Insert the larger end of the USB cable into a USB port on your computer.

What kind of batteries do VTech toys take?

VTech Kids Main Content Insert four AA batteries as shown. Make sure to insert all batteries in the directions indicated.

How do I connect my Innotab 3s to WIFI?

Hold down the button on the console, until you enter the Parent Settings menu. In the Parent Settings menu touch the Wi-Fi icon. If the Wi-Fi is not enabled yet, you should turn the Wi-Fi on. The tablet will list the available networks.

How do I fix my VTech cordless phone?

Reset your Phone If your telephone is not operating normally, disconnect the battery(s) from the handset and disconnect power from the base. After a few minutes, connect power to the base, install the battery(s) and cradle the handset in the base to allow it to establish a link. You can now try using your phone again.