How do I connect my DAP 1520 to WIFI?

Step 1: Plug the DAP-1520 into a wall outlet within wireless range of your router. Step 2: open the wireless utility on your computer, select the name (SSID) of the DAP-1520 network, and enter the password (both of these are found on the included Wi-Fi Configuration Card).

How do I reset my Dlink DAP 1520?

Locate the pinhole on the side where the reset button is. Insert a pin then press and hold the reset button for at least six seconds or until the indicator light turns solid red. The range extender should now be reset to factory default settings.

How do I connect my WPS extender?

How to configure my Range Extender via WPS button to extend an existing wireless network’s coverage?

1. Plug your Range Extender into a power outlet near your main Router/AP.
2. Push the WPS button on your main Router/AP first, then immediately push the WPS button on your Range Extender.
3. The WPS process will last 2 minutes.

How do I connect my Dlink WiFi extender to my router without WPS?

If your router doesn’t support WPS, go to ‘Method 2 – Without WPS button’ opposite. 1 Plug the extender into a power socket near your broadband wireless router (e.g. in the same room). Check the extender On/Off button on the top is switched on. Wait 20 seconds for the extender to boot up.

How do I connect my DAP 1530 to Wi-Fi?

Push the WPS one-touch configuration button, push the WPS button on your existing Wi-Fi device, and you’re done. The DAP-1530 will automatically configure itself. It even includes a built-in setup wizard should you want finer control of wired and wireless settings.

How do I connect my WiFi extender to a new router?

Plug your Range Extender into a power outlet near your main Router/AP. 2. Push the WPS button on your main Router/AP first, then immediately push the WPS button on your Range Extender. Note1: After you have pushed WPS button of your Router/AP, you need to push WPS button of your Range Extender within 2 minutes.

How do I reset my WiFi booster?

We suggest that you to reset your Wi-Fi Booster:

1. Press for at least 10 seconds with a pencil or toothpick into the small hole on the back of the unit.
2. Release when all LEDs except Power and WPS go out. The WPS indicator light will go out after a few seconds.
3. Unplug your Wi-Fi Booster.

What does WPS button do on WiFi extender?

WiFi Protected Setup (WPS) lets you set up your NETGEAR WiFi range extender without typing the network name and password. Not all routers support WPS. If your router does not have a WPS button, you must set up your extender with a different method.

How does WPS push button work?

The WPS button simplifies the connection process Press the WPS button on your router to turn on the discovery of new devices. Then, go to your device and select the network you want to connect to. The device is automatically connected to the wireless network without entering the network password.