Where is blend door actuator on 1999 Dodge Ram 1500?

The electronic blend door actuator is located left of the blower motor on the bottom of the HVAC central housing unit (big black box under passenger side dash).

How do I know if my blend door is broken?

Signs You Need A New Blend Door Actuator

1. Knocking. Knocking sounds can almost always be attributed to a failing blend door actuator.
2. Clicking.
3. Any Other Strange Noises.
4. Inconsistent Airflow.
5. Inconsistent Temperature.
6. Wrong Temperature.

Can you drive without a blend door actuator?

Safety: Can I drive without doing an HVAC Blend Door Actuator Replacement. Driving isn’t a problem for this environmental issue, but your passengers won’t be comfortable or happy. Don’t let them suffer, count on a mobile mechanic from Wrench.

How long does it take to replace blend door?

Replacing the blend door actuator is actually a fairly simple process, and it should take no more than an hour. So the labor will cost you around $75 – $150 depending on labor rates at your local repair shop.

What causes a blend door to go bad?

What Causes a bad blend door actuator? A blend door actuator is linked to an air control door pivot found on the last drive of the unit; a plastic gear set is frequently rotated from one side to another by the electric motor.An actuator can become faulty if the plastic gear set turns out to be fragile and it breaks.

Where is the blend door actuator located?

The blend door actuator(s) are typically located on the climate control case behind the dashboard.

Why is my truck blowing hot air on one side and cold air on the other?

Due to the design of dual AC systems, low refrigerant is the leading cause of drastic temperature difference from one side of the dash to the other. In most cases after the proper charge of Freon is in the car, the temp will blow equally as cold like it should on BOTH sides!

What causes a blend door actuator to go bad?

What does the blend door actuator do?

You want the vehicle you drive in Fredericksburg to blow warm or cool air depending on the season. The blend door actuators, also called HVAC actuators, control the position of the vents that control the flow of air into your vehicle’s passenger area.

Do you have to calibrate blend door actuator?

Calibration is required after a actuator is replaced, but not necessary if power is removed. If you remove power to the system, the mode, temp and air distribution blend doors will self calibrate when power is restored.

Where is blend door actuator located?

Will the OEM blend door break?

The OEM Blend Door is made of metal and does not break. However, it has a weak plastic driver that often fails. Our kit will re-utilize the OEM metal door, but we include a CNC machined aluminum driver to replace the weak plastic driver.

What is wrong with my Dodge Ram?

The Ram has a metal blend door and a metal connector on the actuator motor. The problem is use of a plastic interposer to connect the motor to the blend door axle. The pictures show the plastic OEM component and the steel replacement.

What is wrong with my Dodge heatertreater?

The Dodge is relatively simple compared to our other HeaterTreater products. The Ram has a metal blend door and a metal connector on the actuator motor. The problem is use of a plastic interposer to connect the motor to the blend door axle. The pictures show the plastic OEM component and the steel replacement.

Where are the parts for the Dodge Ram 1500 made?

All parts are manufactured in Michigan and are CNC machined out of solid aluminum. We proudly guarantee everything we produce for life. This kit fill fit 1994, 1995, 1996, 1997, 1998, 1999, 2000, and 2001 Dodge Ram 1500 trucks. It will also fit 1994, 1995, 1996, 1997, 1998, 1999, 2000, 2001, and 2002 Dodge Ram 2500 and 3500 trucks.