What is the default administrative distance of a static route if you use an exit interface instead of a next hop address?

Static routes have a default administrative distance of 1. This route that has an administrative distance of 5 will not be placed into the routing table unless the previously entered static route to the 192.168.

What is the default preference of a static route?

60
The default preference of static routes is 60.

What is administrative distance in routing?

Administrative distance is the feature used by routers to select the best path when there are two or more different routes to the same destination from two different routing protocols. Administrative distance defines the reliability of a routing protocol.

Is the default administrative distance of RIP?

The default administrative distance of RIP is 120.

Which routing protocol has smallest default administrative distance?

For example, Cisco routers, routes issued by OSPF have a lower default administrative distance than routes issued by the Routing Information Protocol. By default, OSPF has a default administrative distance of 110 and RIP has a default administrative distance of 120.

What is default administrative distance of RIP used by Cisco?

120
For example, Cisco routers, routes issued by OSPF have a lower default administrative distance than routes issued by the Routing Information Protocol. By default, OSPF has a default administrative distance of 110 and RIP has a default administrative distance of 120.

What is fully specified static route?

In a fully specified static route, both the exit interface and the next-hop IP address are specified. This form of static route is used when the exit interface is a multi-access interface and it is necessary to explicitly identify the next hop. The next hop must be directly connected to the specified exit interface.

What is the default range of administrative distance?

The range for administrative distance is 0–255. The default value is 120 for RIP routes and 110 for OSPF routes.

Which routing protocol has the most trustworthy administrative distance by default?

By default, OSPF has a default administrative distance of 110 and RIP has a default administrative distance of 120. Administrative distance values can, however, usually be adjusted manually by a network administrator.

Where should we use default routing?

Explanation: We must use default routing on stub networks. They have only one exit path out of the network, so there can be no specific path decided for such networks.

Which one has a highest administrative distance?

Administrative Distance (AD) is a numeric value which can range from 0 to 255. A smaller Administrative Distance (AD) is more trusted by a router, therefore the best Administrative Distance (AD) being 0 and the worst, 255.

How do I set administrative distance for a static route?

To set an administrative distance:

1. For RIP and OSPF, issue the distance command in Router Configuration mode. host1(config-router)#distance 100. The range for administrative distance is 0–255.
2. For IS-IS, issue the distance ip command in Router Configuration mode. host1(config-router)#distance 80 ip.

What is the default admin distance for a static route?

The default admin distance for a static route is 1. 10-17-2005 10:45 PM 10-17-2005 10:45 PM My question is not about the Administrative distance of Static Routing, but about the default Administrative Distance of Default Routing where the destinations are unknown.

What is administrative distance in router design?

Administrative distance is that feature which a router uses to select the best path from different paths which are to the same destination from two different routing protocols. It defines how reliable a routing protocol is. Each if these is prioritized in the order of most to least valuable.

What is the default admin distance for OSPF?

But if you have some kinda routing protocols like ospf to generate the default route and inject it onto the other boxes then you will have the OSPFs admin distance attached to it. for an instance the default route generated by OSPF will have 110 as its admin distance. hope this helps.

What is the ad value of a static route outbound?

This is not true. Both of them are having AD value of 1. The confusion is coming from the info that directly connected interface has AD of 0, but static route outbound that interface is having the AD of 1.